$98.11 $98.11

2 in stock

Shaft Seal Kit for MirOil Filter Machines with R40 Motors

The shaft seal kit is the most common replacement part of the MirOil filter pump. When there are obvious signs of wear, it is best to replace the kit to make the filter pump work most efficiently. This shaft seal kit is compatible with any of the BD & BS filter pump machine series. Only suitable with the R40 Motors.

2 in stock

Shaft Seal Kit for MirOil Filter Machines with R40 Motors

Revitalize your MirOil filter pump with the Shaft Seal Kit designed for R40 Motors, ensuring optimal performance in the BD & BS series filter pump machines. As the most common replacement part, this kit addresses wear and tear, providing a seamless solution for maintaining peak efficiency.

Engineered for compatibility with R40 Motors, this shaft seal kit offers a perfect fit and easy installation. Say goodbye to disruptions in your kitchen workflow as this essential replacement ensures your MirOil filter pump operates at its best, empowering you to maintain productivity with confidence. Choose reliability and sustained performance with the Shaft Seal Kit for MirOil Filter Machines with R40 Motors.

How to Replace Shaft Seal

  1. Make sure there are no burrs or sharp edges on the motor shaft before installing the new shaft seal.
  2. To remove cover, use a 3/16″ allen wrench to remove the four cap screws.
  3. Arrange the pump with the shaft vertical so the rollers do not fall away from the pump when the cover is removed. Remove and save the 5 rollers.
  4. Carefully remove rotor from shaft. Use 2 screw drivers to apply even pressure under webs of rotor to ease the rotor off the shaft.
  5. Make sure pump surfaces are clean. Wipe the rotor, housing and rollers.
  6. Use wrench to remove 2 × 5/16″ bolts holding the pump base to the face of the motor.
  7. Remove the old seal seat from cavity of pump (see diagram below)
  8. Install the new steel seal seat with polished seal face visible.
(Side marked with X goes inside pump see *a)
  9. Make sure there are no burrs or sharp edges on the motor shaft before installing the new shaft seal.
  10. Remove the rest of the old seal parts from the shaft:
Clean the shaft and install the new seal parts on shaft. **Note: Be sure to add oil film to rubber seal inside the carbon seal face before installing it on the shaft.
  11. Reinstall the pump base to the end face of the motor.
  12. Install the rotor back on the shaft and place the rollers back into position in the deep rotor slots.
  13. Inspect the O-ring to make sure it has no cuts. Carefully replace the O-ring in the groove.
  14. There is a line in the castings of the pump end cap and the pump body/base. Make sure these are lined up when reassembling the end cap to the pump base.

Add a light coating of mineral oil to the shaft seal parts & motor shaft.

*a. to steel seal face, and

 

*b. to rubber shaft seal section of carbon seal face

 

4

Step 7 Reference

Using a screwdriver and hammer, gently tap out the old seal seat from the cavity of the pump body. Be careful to not damage the cavity of the body. Once you have the shaft seal on the motor shaft and the steel face in the pump head, apply equal pressure on the pump head while pushing down on the shaft seal. Once the pump head is down, attach the 2 x 5/16

5

Additional information

Weight 1 lbs
Dimensions 15 × 10 × 2 in
Product Number

CAMBIA-SP-PPU170-000SC

Type - Filter Machines

Series - Filter Machines

,

Type of Fryer

, ,

Country of Origin

Manufacturer

Reviews

There are no reviews yet.

Be the first to review “Shaft Seal Kit for MirOil Filter Machines with R40 Motors”

Your email address will not be published. Required fields are marked *